Run the incubator until your thermometer and LCD are reading as close together as possible.– 1 degree) You can add or take away temperature until it matches the desired instrument (thermometer/hygrometer) you are using. If you are 1 degree high (101), then you’ll need to use the cooler button to lower temp. Use the temperature up or down button to adjust the command center.You will see “SET TEMP” and either a (+ or – number) (example: -1.0) The factory default is -1.2.After holding the two buttons for at least (6) seconds, release them.While holding these buttons down, turn power back on to incubator… hold buttons for (6) seconds.Press the Cooler and the Auto buttons at the same time and hold them down.Set your LCD to (SET TEMP 100) degrees and give the incubator time to stabilize.GQF Cabinet Model 2013 Download Follow these instructions to re-calibrate your Command Center 3258 If you planned to buy 2 1502’s, why not get the Brinsea 580 instead? If I were starting over buyng incubators, that is what I would do. I see many cases where people get 2 or more 1502’s. It is interesting to me that on the Strombergs page the Brinsea 580 is exactly twice the price of a GQF 1502, and the 580 holds exactly twice as many eggs. If you have the money to invest, buy them instead of the cheaper domestic incubators, you will have better hatches. ![]() Brinsea and R-COM are the top of the line in non-commercial incubators.Why do all the manufacturers insist on using cheap hardware? These are major investments that people intend to use for decades, so why not use stainless hardware to avoid the inevitable rust? It could not cost that much extra when building them and you would gain a reputation for quality just from that alone! It just makes sense.All that said, this is where I put my most valuable eggs, the ones that can be tricky to hatch (geese, peafowl, etc). New, they come more complete than the others, including egg trays and spacers that are extra for the others. Imported from the UK, these are expensive to buy and parts are expensive, if you can even find them in the US. Middle of the road, this is a good choice for a first cabinet, as lots of people can help you with use, care and maintenance. Often available used and used ones can be a great value if you are handy and can take them apart to clean and replace any parts that have failed. Parts are readily available from multiple vendors. These are the most commonly used in the US. Excellent basic incubator, this is certainly the best value for the money. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |